HCSA-Field-Transmission Real Exam Questions and Answers FREE H35-260 Updated on Jul 13, 2023 [Q45-Q64]

Share

HCSA-Field-Transmission H35-260 Real Exam Questions and Answers FREE Updated on Jul 13, 2023

H35-260 Ultimate Study Guide - ExamcollectionPass

NEW QUESTION # 45
Which of the following options are the basic requirements of DWDM system for light source

  • A. Output standard and stable wavelength
  • B. The method using direct modulation
  • C. Larger dispersion tolerance
  • D. Using LE

Answer: A,C


NEW QUESTION # 46
Which of the following is impossible for the cause of the ETH_LOS alarm?

  • A. Cable or fiber failure
  • B. The cable or fiber of the Ethernet port is not properly connected
  • C. The received optical power of the local network element is too low
  • D. In-port loopback

Answer: D


NEW QUESTION # 47
Which of the following statements is incorrect about the optical layer interfaces OTM-nm and OTM-nrm of OTN?

  • A. n represents the number of wavelengths carried by the maximum capacity,
  • B. r means OTM without OSC function
  • C. OTM-nr.m with OSC signal is OTM-nm.
  • D. m represents the rate. Value can be 1.2 or 3.

Answer: D


NEW QUESTION # 48
Which of the following descriptions are correct?

  • A. EFG2 can provide 2 GE electrical ports
  • B. CD1 can access and process 2 channelized STM-1 services
  • C. L12 can provide 16 E1 interfaces
  • D. L12 interface board can be installed in the slot of OpiX PTN 1900

Answer: B,C


NEW QUESTION # 49
The R-LOS alarm has nothing to do with overhead bytes but only with the quality of the incoming signal

  • A. True
  • B. False

Answer: A


NEW QUESTION # 50
For ODUK SNCP protection, which of the following types does not apply to the pass-through site being an electrical relay site?

  • A. SNC/S
  • B. SNC/S and SNCN
  • C. SNC/N
  • D. SNC/I

Answer: D


NEW QUESTION # 51
During the negotiation between the two ends of the PTN LAG, the device with the smaller system priority number is the master device

  • A. True
  • B. False

Answer: A


NEW QUESTION # 52
opt Datacollector supports black box fault data collection of multiple products. Which of the following products is not supported?

  • A. WDM
  • B. PTN
  • C. NG SDH
  • D. ocs

Answer: B


NEW QUESTION # 53
IEEE 802.1Q defines the structure of VLAN tags, including TPID, PRI, CR, and VLAN ID. Which of the following is used to classify service priorities?

  • A. CR
  • B. TPID
  • C. PRI
  • D. VLAN ID

Answer: C


NEW QUESTION # 54
In the NG-WDM system, which of the following boards supports optical line protection?

  • A. OUT
  • B. DCP
  • C. QCP
  • D. OLP

Answer: D


NEW QUESTION # 55
Regarding the operation of deleting the path from the network management, which of the following statements is wrong?

  • A. Delete the path from the NE layer. Delete the path on the NE side and the NE layer together.
  • B. Once the network layer deletes the trail, the service will not be interrupted
  • C. After the path is deleted from the network layer and the network element, the service will be interrupted
  • D. Deleting a trail from the network layer only deletes the WDM trail at the network layer on the NMS side

Answer: C


NEW QUESTION # 56
Which of the following is the destination MAC address of the Layer 2 header of the data received by the PTN960 from the LTE base station?

  • A. The port MAC of the EPC device connected to the core L3PTN
  • B. The user-side port MAC of the PTN device connected to the base station
  • C. The network port MAC of the PTN device connected to the base station
  • D. The MAC of the base station gateway L3VE on the L2/L3 node.

Answer: D


NEW QUESTION # 57
According to the IEEE 802JQ standard, where is the VLAN ID field on the Ethernet?

  • A. not fixed
  • B. Between the source MAC address and the destination MAC address
  • C. After the source MA dog address and the destination MAC address
  • D. Before source MAC address and destination MAC address

Answer: C


NEW QUESTION # 58
When creating a static TUNNEL, you need to specify the interface of the next hop. Which is the displayed address of the next hop?

  • A. NE LSR-IP
  • B. does not involve
  • C. Next-hop interface IP
  • D. NEIP

Answer: C


NEW QUESTION # 59
Which of the following is the frame indicated by the VC-4 J1 byte by the AU pointer of the current frame?

  • A. None of the above
  • B. Current Framework
  • C. Next frame
  • D. Previous frame

Answer: C


NEW QUESTION # 60
When the switch is working, the device forwards data according to the MAC address forwarding table. Which of the following statements is correct?

  • A. If the MAC address entry of the device reaches the upper specification limit of the device, the device cannot learn new MAC address entries, and the packet is discarded.
  • B. If the destination address of the message is a unicast MAC address, look up the MAC address table, and if found, forward the frame to the corresponding port (excluding the source port)
  • C. If the destination address of the packet is a unicast MAC address, but there is no corresponding entry in the MAC address table, the packet is discarded
  • D. If the destination MAC address of the packet is the broadcast MAC address, it will be flooded to all ports including the source port.

Answer: B


NEW QUESTION # 61
When creating an electrical layer path, what options (Client, ODUK, ODUflex) may cause the route calculation to fail

  • A. Services cannot be created between ports
  • B. Unable to satisfy routing constraints
  • C. Routing resources are unavailable
  • D. The optical power attenuation on the service layer path OCH is too large

Answer: A,B,C


NEW QUESTION # 62
When deploying LAG, which of the following can the traffic load sharing hash algorithm be based on?

  • A. Destination MAC
  • B. DSCP
  • C. Source MAC
  • D. Source and Destination IP
  • E. Source and destination MAC.

Answer: A,C,D,E


NEW QUESTION # 63
MPLS is used to label packets instead of IP forwarding. Which of the following descriptions about MPLS packet encapsulation are correct?

  • A. The MPLS label of the Tunnel carrying the PW, where the S bit is set to 1
  • B. IP packets can be directly carried on the Tunnel
  • C. The Type field in the ETH header is set to 0x8847 to indicate that it is followed by MPLS label encapsulation
  • D. The nested encapsulation of MPLS can only be two layers, PW and Tunnel two layers of labels

Answer: B,C


NEW QUESTION # 64
......

Ultimate Guide to Prepare H35-260 Certification Exam for HCSA-Field-Transmission: https://www.examcollectionpass.com/Huawei/H35-260-practice-exam-dumps.html